1. Installation
1. Transmitter: Red nameplate
Receiver: Blue nameplate
2. Connect the transmitter to a video resource through an HDMI or SDI cable.
3. Power up the device using a DC adapter, battery, or USB-C adapter (5V 2.5A).
4. Install the receiver in a place higher than 1.7 meters above the ground.
Multiple Sets Installation
· Suggest using up to 3 sets of MARS systems at the same time.
· Choose a different channel, and the channel interval should bigger than 2, please use the channel scan function on the RX to check the status of channels, then select a clean channel on the TX.
· Place each RX at least 0.5m away from the other.
Just pure classic stuff from you here. I have never seen such a brilliantly written article in a long time. I am thankful to you that you produced this! megaspin 777
Video Solutions
1414 People Read
|
2
