Mars 4K Installation

1. Installation
1. Transmitter: Red nameplate
      Receiver: Blue nameplate
2. Connect the transmitter to a video resource through an HDMI or SDI cable.
3. Power up the device using a DC adapter, battery, or USB-C adapter (5V 2.5A).
4. Install the receiver in a place higher than 1.7 meters above the ground.


Multiple Sets Installation
· Suggest using up to 3 sets of MARS systems at the same time.
· Choose a different channel, and the channel interval should bigger than 2, please use the channel scan function on the RX to check the status of channels, then select a clean channel on the TX.
· Place each RX at least 0.5m away from the other.

Just pure classic stuff from you here. I have never seen such a brilliantly written article in a long time. I am thankful to you that you produced this!        megaspin 777

this is not an ordinary solutioons vipzone-samples

When a blind man bears the standard pity those who follow…. Where ignorance is bliss ‘tis folly to be wise….        image backlinks

Every year we go to Florida. We like to go to the beach. My favorite beach is called Emerson Beach.

benergyperform